Back The SRC is capable of copying infrared signals from remote controls.
If your device is not listed in the App, you may stil add a custom remote control by copying all or some of the original remote control's buttons.
Please keep in mind that by adding a device in this mode, you will not be able to control it by using Amazon Alexa or Google Assistant voice commands.
Meanwhile, there is a workaround to overcome this lmitation. For each button you wish to control with voice commands, you need to create a smart routine on the App (Smart > Tap-to-Run> Run the Device > Select Button. When the routine is used, the button's signal is activated.
To assign a volce command to this routine, you need to create a routine on the Alexa or Google Home Apps that will call the Lloyd's App routine.
Follow the steps below to add a custom remote control to the App:

1. On the App's main menu, click on the SRC.
2. Click on or "Add Remote Control.
3. Click on  DIY 
4. Select the type of the device you wish to add. If the device is not shown on the list, select"Custorm Type" the list, select it and then select the brand or select Other brand is not listed (only the design may change) If the device appears on if the
5. V. fa device type other than "Custom Type" was selected: a. On the App, press and hold the desired button to copy the original remote control's signal to it. b. A pop-up message will open requesting you to aim closely the original remote control at the SRC, and to press the desired button on the original remote control. The pop-up message will close in 30 seconds if no signal is detected. If a signal is detected, the App wil display a "Detected Signal" message. c. Assign a name to the copied button and click on  Save .
6. "Custom Type" was selected:
   1. Click on  Next Step  until a pop-up message opens requesting you to aim closely the original remote control at the SRC, and to press the desired button on the original remote control.
      The pop-up message will close in 30 seconds if no signal is detected.
      If a signal is detected, the App will display a "Detected Signal" message.
   2. Assign a name to the copied button and click on "Save". clIfyou wish to copy more buttons, tap  Continue . When you have finished copying buttons, tap  Save .
7. . Your device is ready to be controlled. The new remote control will appear on the main menu and also in the SRC menu (use back arrow to reach the SRC menu). You may change the device's name by clicking on the small edit pen next to the current device's name. This is useful if you have multiple devices of the same type.